INTRODUCTION
The Fast-XL Frame grabber is
for OEMs and End Users who anticipate a demand for extreme I/O requirements
or higher band width for FastVision's FastCamera 13 and FastCamera 40
series CMOS cameras in a cost effective platform. The Fast-XL, see below,
is a AT length PCI board with 80 bit Camera Link Channels which provides
input for the newest high speed cameras. Finally the Fast -XL interfaces
to the host computer through a PCI interface for state-of-the-art data
acquisition.
FAST-XL KEY
FEATURES
The diagram below outlines
the basic functional section of the FAST-XL board. These are:
- Raw PCI form factor board
with 1-4 GB dedicated high speed DDRAM for sustained real-time on-board
storage
- Collects data from up to
80 Bits of asynchronous Camera (channel) Link channels
Cameralink
Specification(
286.6KB)
- PCI Bus interface with 32
bit downward compatibility
- Drivers for Windows®
9X/NT/2K
click
to enlarge
FAST-XL CONFIGURATION OPTIONS
I/O Options
- Up to80 bits Camera (channel)
Link I/O
Camera Control
- Serial port – Asynch. RS-232,
600–19,200 Baud
- Camera Link controls (optional)
Memory Options
- One to four gigabytes of
SDRAM memory directly connected to the input FPGA for high-speed input
PCI Interface
- Clock rate – 33 MHz
max.
- Data width – 32 bits
- Peak DMA rate –110
MB/Sec .
Click here to Download the Datasheet
To Top of Page
